How To Install Replace Door Hinge Pin Chevy GMC Pickup Truck SUV - 1AAuto.com

HI thank you for viewing our GMC door hings pin repair video. If we happen to do this repair in the future, we'll keep this request in mind.

The holes in my hinges are elongated very badly. Any fix for this? Thanks.

hey mike,
i watch your videos all the time. on these doors what hapens when the hinge holes have become elongated? and do the doors on these trucks leak water from the seal when the hnge becomes bad?
thanks for your time

I replaced my pins on my drivers side about a year and a half ago. Well they are already shot. Any grease or special lube you could use to keep them from wearing so fast?

My door still sags

where can i find how to put the spring back in? thank you

I usually have a pretty strict policy of not buying parts over the internet as in the past they have shown themselves to be of poorer quality. However, because i've used these videos that you make so much I think I will give 1a-auto a try. Keep it up.

Thanks for the video. Only problem I ran into was the springs. Did you end up making another video in regards to putting the springs back in? I tried many different tools (pliers, vice grips, etc.) but to no avail. Thanks again.

Great video, is there any way you can do the door pins and bushings for a 2003 gmc sierra with newer body style? The hinges have 2 pins and bushings per hinge.

Thank you so much on this tutorial! I need to do this on my 1988 GMC Sierra since the drivers-side door is a bit saggy. Thanks again! :)

Great Video!! I did this job this afternoon in about an hour by myself. I just used a large air car lift jack that has two pedestals rather than one, and I duct taped a soccer ball to the jack to fill the gap between it and the door, and then cargo strapped the jack to the door... the only problem I had was that dang spring!... after the 6th attempt of the evening... I decided to tackle it tomorrow morning when I'm fresh. Even as an experienced mechanic, I would have not done this without this.

Thank you so much for this video. I would be up the creek without without a paddle without your help on the matter.

Good trick when doing this is to roll the window down.  Not only will you not hit it with anything but you have more options to hold or grab from.